Delem
V0614, 2.32
To record a bend cycle, use the ‘start measure’ command. The program will show the
following dialog:
Figure 2.n
This means the analysis tool is now waiting for a bend cycle to be executed. Now switch to
the DA application and execute a bend cycle in the normal way. The analysis program
actually starts recording when a fast closing or a pressing command is activated. The
program will continue to record until an UDP (upper dead point) signal is generated,
indicating that the bend cycle is finished.
Closing
Pressing
t
UDP
Figure 2.o
When the bend cycle is finished, switch back to the analysis program. On the screen you can
see a graphic of the beam position as a function of the cycle time.
As already explained, each recorded cycle is stored in a file. So it is also possible to open a
previously recorded file for further analysis.
