15
©
2001 Directed Electronics, Inc.
To enter or exit Valet Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The status LED will light solid if you are entering Valet Mode, and
it will go out if you are exiting Valet Mode.
The operations described in this section indicate transmitter
buttons that correspond to the standard configuration. Remember,
this may not be how your transmitter is set up.
1.
Open any door.
2.
Press .
3.
Press .
4.
Press again.
The status LED will light solid if you are entering Valet Mode, and
it will go out if you are exiting Valet Mode.
Your system has DEI
®
’s Nuisance Prevention
®
Circuitry (NPC
®
), which
prevents annoying repetitive trigger sequences due to faulty door
pin switches or environmental conditions such as thunder, jack-
hammers, airport noise, etc.
Nuisance Prevention Circuitry
Remote Valet
DRW-35
