-7-
142657 - Manure Spreader (17-March-2016)
Preparation
TRACTOR PREPARATION
Although there are no operational restrictions on the
Manure Spreader when it is new, there are some
mechanical checks that must be done to ensure the long
term integrity of the unit. When using the machine for
the first time, follow this procedure:
IMPORTANT
:
It is extremely important to follow
all of the procedures especially those listed in the
“Before using” section below to avoid damage:
A.
Before using:
1. Read Safety Info. & Operator’s Manual. Do not
operate the spreader until the safety precautions in
this manual and the decals on the spreader have
been read and understood by the operator.
2. Check for proper assembly and adjustment and
make sure all bolts are tight. All bolts were
checked at the factory
when assembled but
need to be checked
again as vibrations in
shipment may loosen
them slightly.
3. Complete steps in “Pre-Operation Checklist”.
4. Lubricate the machine completely. Refer to the
Lubrication section of this manual (p.14). The
initial grease was applied at the factory but
proper maintenance is the user’s responsibility and
must begin before the first use.
NOTE:
Ensure driveline is properly lubricated,
especially the driveline CV as it is not originally
lubricated from supplier.
5. Operate the machine slowly for a period of time to
run the chains in and confirm that all parts work
freely.
B.
After operating for 2 hours:
1. Retorque wheel bolts.
2. Check torque on the driveline cut-out clutch
bolt (taper pin). Tighten to 75 ft-lbf (102 N·m)
3. Check all hardware. Tighten as required.
4. Check all hydraulic system connections.
Tighten if any are leaking.
5. Tighten chain.
C.
After operating for 8 hours:
1. Repeat Step B.
2. Go to the service schedule as outlined in the
“Service & Maintenance” section.
SPREADER PREPARATION
Follow this procedure when selecting and preparing
a tractor for use with the machine:
1. Use only a tractor of sufficient power and
weight to adequately handle the machine. It
is recommended that the tractor have at least
180 PTO
horsepower for normal operating
conditions.
2. It is recommended to pin the drawbar in its
centre draft position.
3. Use only a drawbar pin with provisions for a
mechanical retainer such as a Klik pin. Always
install the retainer.
4. Always attach a safety chain between the
tractor and the machine to prevent unexpected
separation.
5. The drawbar pin to 1000 PTO shaft end
dimension should be either:
16 inches for 1-3/8, 21 spline PTO models
20 inches for 1-3/4, 20 spline PTO models.
IMPORTANT
:
Do not use on a tractor equipped
with a PTO shaft adapter to prevent
mismatching of PTO speeds and over
telescoping of the driveline.
20 inches
16 inches
1-3/4 - 20 Spline
1-3/8 - 21 Spline
Recommended Wheel Bolt
Torque Specs:
280-300 ft·lbs (380-405 N·m) -dry
220-240 ft·lbs (300-325 N·m) -lub.
Note:
Recheck torque on wheel
bolts after a couple of hours, and
following day.
Summary of Contents for M28
Page 2: ......
