-14-
142657 - Manure Spreader (17-March-2016)
Cross Joints
(both ends)
Slider
Shaft/Tube
Guard Bearings
(both ends)
Over Running
Clutch
8 Hrs.
8 Hrs.
8 Hrs.
8 Hrs.
8 Hrs.
CV Joint
(*15 pumps)
Service & Maintenance
SERVICE INTERVALS
LUBE AFTER EVERY 8 HRS.
CAUTION
:
Machine may be shown with
guard(s) opened for illustrative purposes only.
Close all guards before using.
Initial & after every 8 Hrs.
-
check for hydraulic fluid leaks
and damaged hoses
-
check tire pressure (65 psi) /
Optional Tires
(58 psi)
- initial wheel bolt torque (recheck - 2 hrs/8hrs):
Dry: 280-300 ft·lbs Lube: 220-240 ft·lbs
-
grease front driveline:
•
CV Joint
- drive end (15 pumps)
(Important: Ensure CV is greased before first use!)
•
Over running clutch - (5 pumps)
•
slider shaft/tube
- center
•
cross joint fittings
- both ends
•
guard bearings
- both ends
•
front hitch
- both sides
Check
Gearbox
Fill if required
Check
Gearbox
Fill if required
40 Hrs.
40 Hrs.
Slider
Shaft/Tube
Cross Joints
(both ends)
40 Hrs.
40 Hrs.
40 Hrs./ Weekly
-
grease rear driveline:
•
cross joint fittings
- both ends
•
slider shaft/tube
- center
-
grease chain axle endcaps - front/rear
-
check gearbox oil levels - 2 gearboxes
Hydraulic Motor Gearbox - Rear right hand side
• Oil should be level with middle of sight glass.
• Add as required through top plug.
Rear Beater PTO Gearbox - Rear, under beaters
• Oil should be level with middle of sight glass.
• Add as required through top plug.
• Oil may take awhile to distribute in casing,
recheck level after 30-40 min. and repeat if
necessary.
Annually
Annually
Check/Adjust Chain
tension
(both sides)
Check/Adjust
Axle Support
Grease Chain Axle Caps
(front/rear)
40 Hrs.
Slider
Shaft/Tube
8 Hrs.
- 5 pumps
CV
-15 pumps
8 Hrs.
Cross
Joint
8 Hrs.
CV Joint
(*15 pumps)
8 Hrs.
Guard
Bearings
8 Hrs.
Over running
Clutch
(*5 pumps)
8 Hrs.
Cross
Joint
8 Hrs.
Guard
Bearings
8 Hrs.
Annually
•
check general hardware/bolt tightness
•
check/adjust chain tension
Hitch
(both sides)
8 Hrs.
Summary of Contents for M28
Page 2: ......
