Electrical connection
N1 L1 Electrical Grounding
Power supply 220Vac. +/- 10% 600 Watt (2.1A)
• Supply the machine by connecting the mains cable to the appropriate terminal, printed: "
N1 L1
",
located on the electronic card.
• Connect the system grounding to the specific Faston fixed to the frame
Note: Prepare a dedicated 220V power supply line,
with a switch and adequate protections.
Input-Output connection (commands)
+ 12V -
Output 12vdc max 500mA protected by fuse (F7) to power external devices.
LEVEL
(Liquid Level)
"Clean" contact NC H24 (normally closed) when the DEFENDERTECH liquid level is acceptable. It
will open when the level is in "reserve" (at least 60 "of autonomy available).
It is recommended to bring the contacts to the control panel and create an unarmed area for
signaling purposes.
Note: T
his contact can be used to assign other functions, see p. 14 "special features"
STATE
(system status / failure signal)
When the appliance is disarmed or switched off, the "Clean" NA contact (normally open) will be
close in when the machine receives the command to arm.
The tamper placed on the left side of the appliance "
is in series
" with this output.
If a malfunction occurs, the "STA" contact will open.
It is recommended to bring the contacts into the central unit and create a delayed zone of 0.5 ''
not alarmed in order to signal the status of the machine.
Note:
This contact can be used to assign other functions, see p. 14 "special features"
