USE R M ANU AL
TOUCHSCREEN 2.1
5
SEPTTEMBER 12, 2017
Using the RJ-45 socket
Use a regular Ethernet cable and plug one
end into the back of the display and the other
end into the socket on the board. If you build
your own network cable, crimp a RJ- 45 plug
onto each end using the T568-A wiring
standard described on page 6.
WARNING!
Do NOT
connect another serial
port device, including another touch display, to
the port C terminals on header JCOM when
the RJ-45 socket is used!
RJ-45 socket and header JCOM share
communication port C.
Figure 1. RJ-45 socket
on Supervisaire board
Using Port D on J8
If you want to connect a second display you must use Port D on header J8.
If you have a premade cable, cut off one connector. The other connector should
be plugged in to the display. If building your own cable, use the T568-A wiring
standard described on page 6
The wires on the cut end are wired to header J8 as follows:
Pin 1
–
Solid and striped blue wire
Pin 2
–
Solid and striped brown wire
Pin 5
–
Striped green wire
Pin 6
–
Solid green wire
