07
07
CLEANING
1. Disconnect the power supply before cleaning.
2. Empty the chopping jar, dismantle all detachable parts and
rinse them in warm soapy water. Extreme caution must be taken
when handling blade as it is very sharp. All the accessories
except motor base are dishwasher safe components, but
the temperature setting shall not exceed 70
℃
. Then dry
thoroughly.
3. Wipe the outside of base with damp cloth. Never immerse
it in water as electric shock is possible to occur. Then dry
thoroughly. Ensure the interlock area is free of food particles
.
FOR A QUICK WASH UP
Between processing tasks, pour in some water into the
chopping jar, turn and hold the speed selector to P position a
few seconds for quick cleaning.
SLICING/CHIPPING/SHREDDING
1. Firstly assemble the driving shaft into the motor base, make
sure it is clipped into position.
2. Place the chopping jar on the Motor Unit from the unlock
position and slightly turn the chopping jar clockwise until the
chopping jar locks into the lock position on the motor base.
Make sure it is assembled in place correctly, otherwise the
appliance will not operate.
3. Fit the shredding blade or slicing blade or chipping blade
(coarse or fine) into the disk stand, place them in the bowl.
NOTE: For assembling, first push in the no block side, then
push in the other side. For disassembling the blade from the
disk stand, first push out one side with no block, then push
out the other side.
4. Place the lid onto the chopping jar and turn it clockwise until
the tab of the lid clicks into slot in the jar handle. Make sure it
is locked in position correctly, otherwise the appliance will not
operate.
5. Turn the speed selector to 1 or 2 setting to start.
Note: the shredding/slicing/chipping disks can slice thickly-
potatoes, onions, carrots…
6. Use the food pusher to feed food into the feeding funnel. The
food shall be cut into proper size to suitable for the feeding
funnel. You can slice/chip up to 1000g of food.
7. Minimum 2 minutes rest period must be maintained after
one operation cycle. At least 30 minutes rest period must be
maintained to let the appliance cool down after three operation
cycles.
8. Turn the speed selector to “0”position and unplug unit after
processing. Remove the blade ass’y. Unlock jar by turning it
