DBI SALA First-Man-Up, User Instruction

Page: 9 / 24

9
D. SECURING THE TIE-OFF ADAPTOR TO THE ANCHORAGE:
Step 1. Extend the extension pole to the length required to reach the anchorage.
The strap rod must remain in the locked position. Ensure the trip cord
remains attached to the pin on the lever arm.
Step 2. Rest the strap arm with tie-off adaptor on top of the anchorage. The wider
web (which acts as a wear pad) must be against the anchorage, as shown in
Figure 7. Ensure the tie-off adaptor web is not twisted. Pull the trip cord to
release the strap rod, which will allow the tie-off adaptor to drape over the
anchorage with both D-rings hanging below the anchorage. Using the hook
on the tie-off adaptor connector tool, position the tie-off adaptor so that it
drapes evenly over the anchorage.
Figure 7