Ver 2.0 and up
iBoot
Page 13
iBoot Setup
iBoot setup section consists of several pages. Access any page via the
buttons on the left of the page. Each time a setting is changed click on the
Apply button for that page to save the changes in iBoot.
Device Settings
Device Name
: Set a 20
Character
name to be displayed on the
top of the
Home page. This assists in
identifying which iBoot is
being
accessed.
Cycle Time
: 0 to 999
seconds
power cycle time. This is the
length of
time the power will be off
during a
reboot, or on during a power
burst.
TCP/IP Settings
IP address
: Enter either a
new IP
address, or address
0.0.0.0
to
enable
Automatic IP addressing via
DHCP.
Once you click Apply for this
section,
also click the Reboot button
that will
appear at the top of the page.
The new
IP address will not take effect
until the
unit is rebooted.
Upon Clicking Reboot, a page indicates the new
URL for
the device. Use this new URL to access iBoot.
Subnet Mask
: Change if required. Consult your network manager for more details.
This will be automatically set if using DHCP
Gateway
: Change if required. Consult your network manager for more details. This
will be automatically set if using DHCP
HTTP Port:
This setting is used to allow access to iBoot on a port other than the
Web standard Port 80. If the port is changed, you will need to identify the port