9
Flammable and explosive substances must definitely be kept away from the
water heater, they must not be at the same place.
After mounting, the hole opened for the waste gas pipe in the wall, should be
filled with a substance resistant to burning and it should be isolated.
Electric connection of the heater must be grounded and 6 amper fuse must have.
The wall, which your water heater is mounted, should be strong as to carry the
weight of the water heater.
The installation of water heater should not be made on the power supplies
The wall, which your water heater is mounted, should be strong as to carry the
weight of the water heater and installation metarial is fixed safetly.
Be careful to avoid any accident while installing the water heater.
For installation to suitable place according to above determined conditions;
Drill at least two holes of appropriate diameter from the bottom and top of the
device according to the measurements of the water heater mounting holes
Fix the appropriate diameter fixing plug to the holes.
Drill 135 mm waste gas pipe hole to the wall. . (Waste gas pipes are provided
with water heater.)
All drilling must be made before water heater install to wall. Precautions should
be taken to prevent wastes entering the water heater that occur during drilling.
After drilling pipe hole, Screw the water heater from up and down to holes that
you drill before. Screw more than point that is necessary.
Screw more than point when it is necessary
.
Qualifiable pipe must be used for this device.
The gas flue pipe should be placed at an angle of 3 degrees with the horizontal,
with its end inclined downwards.
Place the fresh air / discharge gas pipe as open side will be outside to hole which
is drilled before for the exhaust.
Install the bracket part as installing one edge is to heater pipe another edge is to
discharge pipe.
5.2.1. Waste Gas Pipe Installation
5.2. Wall Installation Of Water Heater
