daviteq Lidar People Counter, Manual

Page: 47 / 93

The calibration will be done by changing the A & B factors on the wireless transmitter part. Please refer to the manual
for the wireless transmitter to know how to change those A & B factors.
Diagram for re-calibrating the AC current transducer
The Daviteq AC current transducer together with a wireless transmitter to be used in the following cases:
To measure the current load, power of the machine, equipment...to record the current load by time and detect
when the load is over the threshold for protection, for safety.
From the current load, the sensor can count the run time of the machine, equipment to deliver output how many
hours of run, and how many hours of OFF, by setting the suitable threshold.
Use the crimping tool to make the connection and protect the connection with a PVC heat shrink tube as below photos.
Note: the calibration of the AC current transducer must be carried with the wireless part (Sub-GHz or Sigfox or
LoRaWAN) as the calibration factors A and B are stored on the memory of the wireless transmitter.
4. Application notes for the Daviteq AC current
transducer
5. Installation Procedure
5.1 Connect the CT with the AC current transducer