34 Installation
(for qualified installers only)
© Travis Industries
9/25/17-1468
Maestro
Intake Dampers
WARNING
:
DO NOTE CONNECT THE INTAKE DAMPER WIRES TOGETHER – THIS WILL SHORT THE SYSTEM.
Provisions for an intake damper(s) are included with this fireplace (24V AC wires). Intake
dampers are recommended for all residential applications. Connect the intake duct to the damper
and route to the termination (if applicable).
If you live in the shaded regions shown in the
illustration to the right, we strongly
recommend using intake dampers (except in
cases where the air being drawn in is
conditioned or part of an air inlet system). In
addition, use insulated air ducts and insulate
the fireplace enclosure.
If the fireplace is located in an area with
negative pressure, we recommend intake
dampers to prevent air from being drawn into
the fireplace when it is not in operation.
The intake damper wires may be routed from the fireplace inside or outside the ducting to the
damper. Attach the damper wires to the damper (wire orientation does not matter). These wires
may be shortened or extended using suitable wiring. When installing, make sure all excess wire
is positioned away from the damper so it does not interfere with damper operation.
After installation, turn the fireplace on and visually check the intake dampers to verify they open
correctly.
If using intake dampers, they must be located in an area that will allow them to be serviced at a
later time. In addition, the dampers should be placed so their operation can be verified.
Air intakes in Warm Environments
The DaVinci Custom Fireplace™ uses air-cooled glass to ensure proper temperatures near the viewing
area. If operating the fireplace when the outside temperature is hot (above 90 deg. F.), you will notice the
glass will become warm to the touch. When temperatures are more moderate, the glass will be cooler.
Although this is not a safety issue, we do believe all fireplace viewers (and installers) should be aware of
this. If you do anticipate operating this fireplace with higher outside temperatures, you may wish to pull
the intake air from a cooler location (e.g.: shaded side of the building, conditioned air, etc.).
