Setting Up
6
ergo_memo-card2
Protection
slider
Safety button
18 levels
Vertical adjustment
Loosen the spring loaded tommy head button
2
by one to two turns, and then
pull it out. Move the saddle column up or down to the required height. Release
the tommy head button and move the saddle column a little bit up or down until
the protruding red safety button on the tommy head button locks in. Then tighten
the tommy head button.
For safety reasons height adjustment is only possible up to level 18!
360° continuous
Switching ON / Off
Please read the safety notes before switching the ergo_bike premium8 on, and
follow the installation and assembly instructions.
Insert the ergo_memo-card2 in the dashboard before switching the device on.
Use the On/Off switch " I " on the lower rear section of the device to switch it
on and off.
3
2
13cm
1
Handlebars adjustment
Loosen the star knob
3
adjust the handlebars to the required position and
tighten the star knob back.
On / Off power switch
Saddle adjustment
Horizontal adjustment
Loosen the lever
1
slide the saddle to the required position and then tighten
the lever again.
The lever should point to the rear after tightening. Pull and turn the lever to point
to the rear.
- risk of injury.
When switched on, the system takes about 1 minute to load the software. The
colour screen displays during this time a software load progress bar.
Wait for the beep signal before using the dashboard.
If the memory card is inserted after the Premium device is switched on, then
you must wait for the beep signal. This can take about 5 seconds. (if the card
is empty it will be initialised)
In principle the memory card should be pulled out while you are not pedalling
or only after the beep signal!
The protection slider on the ergo_memo-card2 must point to the bottom when
the card is inserted into the dashboard. This will make it possible to write to the
card.
If the slider points upward the card is locked/write protected.
If the card is empty it will be initialised. Only then can you use a computer to
save e.g. mp3 files (in the \mp3 folder) or update files (in the \update folder) on
the card.
The maximal cards size is to 1GByte.
Notes to the handling of SD cards (page 16)
In the case of a commercial use (whenever the device is used frequently on a
daily basis) we recommend switching it ON in the morning and then switching
it OFF once at evening.
Wireless Pulse rate Measure
The ergo_bike medical8 is equipped with a Polar receptor module, and can thus
receive coded pulse rate signals only.
Summary of Contents for ergo_bike medical8
Page 1: ...medical Operating Instructions 0650682e 0004 0297...
Page 23: ......
