Operation
3-5
Call Button
The CALL button initiates a call sequence in the ALE option or in the
Transcall, Selcall, or TransAdapt option. If these options are not
installed or if they are turned off, this button is disabled. For informa-
tion on placing ALE calls,
refer to the Placing an ALE Call section on
page 3-20.
For information on placing Transcall, Selcall, or Trans-
Adapt calls,
refer to the Placing a TransAdapt, Transcall, or Selcall
section on page 3-21.
Internal Options
The OPTION and STATUS buttons allow the status of certain
installed options to be changed. The options that can be controlled by
these buttons are:
When an option is installed inside the TW7000, a corresponding icon
is shown on the left side of display area. The icon and the option’s
current status (ON or OFF) displays permanently.
To change the status of an installed option:
1.
Press the OPTION or STATUS button. The icon of the last
entered option flashes.
2.
If a different option is desired, press the OPTION button until
the desired icon flashes.
3.
Press the STATUS button to toggle between ON and OFF (or
between 1, 2, 3, 4, and OFF in the case of the Encryption
option).
When pressing any button other than OPTION and STATUS, the
icon stops flashing and the function of that button is performed. The
icon also stops flashing if no changes are entered after a time-out
Icon
Option
ALE
FED-1045 ALE
TC/SC
Transcall/Selcall
TA
TransAdapt
NB
Noise Blanker
OPT
Voice Enhancement
ENCR
Encryption