22
Basic Mode
Start
Output
Sdi 1
Pgm
Sdi 2
Input 2
HDMI
MultiV
Keyer
HDMI
1080P
Chroma
Audio
Mode
On
Level
Auto
P-in-P
Sdi 1
On
Sdi 2
On
HDMI
On
P-in-P Lite
Inputs
Outputs
Stills
User Mems
Setup
Outputs
In general, there are three output ports (
SDI 1
,
SDI 2
and
HDMI
) available, which can be configured to
output one of the following:
•
Input 6
•
Input 5
•
Input 4
•
Input 3
•
Input 2
•
Input 1
•
CLN PVW (Clean PVW)
•
CLN PGM (Clean PGM)
•
PG + DSK
•
PVW
•
PGM
•
MultiV (Multi view)
In addition to selecting your output source, you are also allowed to set two different resolutions to the
HDMI output port. The two available resolutions are 1080i and 1080p.
Please note that when HDMI OUT is set to 1080i, image will be enlarged on the DELL 24” monitor (Wide
Mode = 1:1), exceeding the viewable screen area (overscan). In 1080p and 720p modes, image overscan
and shifts are seen on BENQ 37”/SONY 42” TV.
Audio
The Audio sub-option for the SDI and HDMI outputs allows the user to individually turn ON/OFF the
embedded audio component at the
SDI1-out
,
SDI2-out
and
HDMI-out
.
Mode
(On/Off): The SE-1200MU can only accept external audio using the analogue XLR inputs on the
rear panel. Ideally a master audio mixer would be used alongside the SE-1200MU. A Datavideo AM-100
or AD-200 could be considered. By changing the Audio sub option from ON to OFF will mute the
incoming XLR audio from the external master audio mixer.
Level
(EBU/SMPTE/AUTO): There are two different audio standards available for selection. The user can
either select the EBU or SMPTE standard. By selecting AUTO allows the device to automatically detect
the audio standard.
Summary of Contents for RMC-260
Page 1: ......
Page 34: ...34 Service and Support ...
