19
Advanced Mode = Basic Mode
Start
P-in-P Src
Key 1
Keyer
Position
X
20%
Y
10%
Size
50%
Chroma
Border
Luma
0%
Sat
0%
Hue
0
P-in-P
Width
0%
P-in-P Lite
Inputs
Crop
Left
0%
Right
0%
Size
0%
Outputs
Top
0%
Bot
0%
Stills
User Mems
Setup
Position
The user can adjust the P-in-P window position by adjusting values of
X
,
Y
and
SIZE
, where X is the
horizontal position, Y is the vertical position and Size is the P-in-P window size.
X
Y
Size
Positive value: position the
P-in-P window to the right.
Negative value: position the
P-in-P window to the left.
Zero value: Position the P-in-
P window at the center.
Positive value: move the
P-in-P window up.
Negative value: move
the P-in-P window down.
Zero value: Position the
P-in-P window at the
center.
Ranges from 0 to 100 with 1% being the
smallest and 100 being the largest. So 50%
would represent a P-in-P window which is
half the size of the background image. 100%
would see the PIP image totally cover the
background image unless offset to one side.
Border
P-in-P window border color can be set by adjusting the
Luma
,
Saturation
and
Hue
values.
Border Width
The “
Width
” sub-option adjusts the border width. A width of zero (0) will turn the P-in-P window border
off.
Crop
The P-in-P window crop can be adjusted by modifying the following parameters:
•
Left
– Adjusts the position of the left edge of the P-in-P window.
•
Right
– Adjusts the position of the right edge of the P-in-P window.
•
Size
– Adjusts the P-in-P window crop size.
•
Top
– Adjusts the position of the top edge of the P-in-P window.
•
Bot
– Adjusts the position of the bottom edge of the P-in-P window.
4.5 P-in-P Lite
P-in-P
Lite option allows the user to adjust related P-in-P parameters
EXCEPT
its vertical position and the
P-in-P
window size. Enter this option if the user selects
P-in-P Lite
in the
Keyer
option. “
P-in-P Keyer
”
sub-option will indicate the keyer enabled for P-in-P Lite. In our example below, the
Key 1
keying effect
will be applied to the P-in-P Lite window.
Summary of Contents for RMC-260
Page 1: ......
Page 34: ...34 Service and Support ...