Datas Technology D-100 Series, Installation Manual

Page: 12 / 42

Installation Manual
12
Physical Description
The D-100 Host is housed in a 17"w x 1.75"h x 10"d enclosure, which is 1 EIA rack-mount
space high.
Front Panel Layout
The front panel contains connections for eight sensor inputs, microphone input, Ethernet port, serial
port, and status LEDs. See figure below:
Figure 1: Front Panel Layout of the D-100 Host
1 Serial Port
2 Ethernet port (10Base-T)
3 Phone line
4 Sensor Inputs (8)
5 Battery Power Alarm LED
6 AC Power Alarm LED
7 External Microphone Input
8 Internal Microphone
Serial Port
The RS-232 serial port is used to configure network settings. The port operates at 9600 baud, no
parity, and 1 stop bit.
RJ-45 10BASE-T Ethernet Port
This jack is for connecting to your network so that the D-100 Host can communicate with the
D-100 Nodes and ping selected network servers and/or services. Two LEDs indicate received
data (green) and transmitted data (yellow).
Phone Jack
Connect the D-100's Phone jack to a standard 2-wire analog phone line. The unit dials using
touch-tones, with loop start only. The D-100 will recognize ringer frequencies from 16 to 60 Hz
and will operate with all standard analog telephone systems that accept tone dialing.
Certain private telephone systems and public switching equipment may not accept the unit’s dialing
or may generate an unacceptable ring signal. In those cases, a dedicated line may be required for
the unit. Consult the supplier of your telephone system if you encounter problems.
CAUTION: Never install telephone wiring during a lightning storm. Never install
telephone jacks in wet locations unless the jack is specifically designed for wet
locations. Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface. Use caution when installing or
modifying telephone lines.
!
Host
Infrastructure Monitoring System
SERIAL ETHERNET PHONE
E n v i r o n m e n t a l S e n s o r I n p u t s
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
MIC
BAT AC
POWER
ALARM
IMS
S
O
L U T I O
N
4
7 2 1
3
5
6
8
12