Datas Technology D-100 Series, Installation Manual

Page: 16 / 42

Installation Manual
16
Wall Mount Installation
The D-100 Host can be wall mounted using the optional wall mount brackets. Follow the steps
below:
1) Remove the rack mount brackets with a Phillips screwdriver.
2) Attach the optional wall mount brackets to the sides of the D-100 using the eight black
#6-32 screws. A Phillips screwdriver will be required. (Order part # D-4501 Universal
Wall Mount Kit)
3) Attach the unit to the wall using two screws per side. Tighten the screws with a Phillips
screwdriver.
4) Plug the power cord into a 90-260VAC outlet.
Figure 4: Wall-mounted Host Unit
Tabletop Installation
The D-100 Host can be installed on a tabletop or shelf. Follow the steps below:
1) Remove the rack mount brackets with a Phillips screwdriver.
2) Attach the four self-adhesive rubber feet to the four corners on the bottom of the D-100.
3) Place the unit on a tabletop or shelf and connect the power cord into a 90-260VAC outlet.
Figure 5: Tabletop-mounted Host Unit
Power On Self Test (POST)
When the power switch is turned on, the red and green input LEDs will begin a blinking pattern to
indicate that the unit is booting up and performing internal diagnostic tests. The unit will also beep
once, 25 seconds after power is applied. When the LEDs stop blinking, the unit is fully booted and
operational. The boot and Power On Self Test take approximately 2 minutes.
IMS
S
O
L U T I O
N
SERIAL ETHERNET PHONE
E n v i r o n m e n t a l S e n s o r I n p u t s
1 2 3 4 5 6 7 8 MIC BAT AC
POWER
ALARM
IMS-4000
1 2 3 4 5 6 7 8
Infrastructure Monitoring System SENSAPHONE ®
Host
I M
S
S O L U
T
I O
N
SERIAL
ETHERNET
PHONE
Environmental Sensor Inputs
1 2 3 4 5 6 7 8
MIC
BA
T
A
C
POWER
ALARM
IMS-4000
1 2 3 4 5 6 7 8
Infrastructure Monitoring System
SENSAPHONE
®
Host