Datalogic VLASE IR 1109-1 42 Series, User Manual

Page: 43 / 136

LASER MARKER STATE
USER MANUAL
35
LASER MARKER STATE
Normal Operation States
This state occurs since the laser marker is
switched on until Laser Engine has been loaded
and no errors occurred
Blinking
In this state the laser marker cannot emit IR lasers
radiation and Aiming beam cannot be activated
Steady
In this state the laser marker is performing the
warm up process
Blinking
In this state Aiming and Focus beam can be acti-
vated while the laser marker cannot emit IR laser
radiation
Steady
In this state the laser marker is able to emit IR
laser radiation
Steady
Error States
This state occurs if the laser marker detects an
error that prevents normal operation
Blinking
This error rise if the INTERLOCK function is ON. To reset the error, set
INTERLOCK function to OFF and repeat the turning on sequence
This error rise if the CONNECTOR_PRESENCE signal (pin 10 Com-
mand Box connector) is LOW or not connected. To reset the error, set
CONNECTOR_PRESENCE signal to HIGH value and repeat the turning
on sequence
This error rise if the temperature inside the laser source is out of the
operating temperature range. To reset the error, a Laser marker
restart is required
This error rise if the laser source detects an internal failure. To reset
the error, a Laser marker restart is required
Warning State
This state occurs if the turning on sequence has
not been followed. To restore normal laser marker
operation, repeat the turning on sequence
Blinking
STATE DESCRIPTION STATUS LED
SYSTEM BOOTING UP
WAIT FOR START
WARMING UP
STANDBY SHUTTER
CLOSED
READY
STATE DESCRIPTION STATUS LED
ERROR
SYSTEM ERROR DESCRIPTION
INTERLOCK ERROR
TEMPERATURE ERROR
MASTER OSCILLATOR
ERROR
STATE DESCRIPTION STATUS LED
WARNING INVALID
START SEQUENCE