USE AND OPERATION
60
VLASE™ IR
2. activate the command KEY, by rotating it clockwise:
Figure 3: Enable command KEY
When the KEY command is enabled, the status LED on the rack will be blinking orange
for about 30 seconds (laser source warm-up).
Wait until laser source warm-up finishes. The status LED on the rack will be steady
orange.
Figure 4: Standby Shutter closed state
Summary of Contents for VLASE IR 1109-1 42 Series
