Datalogic VLASE IR 1109-1 42 Series, User Manual

Page: 35 / 136

CONNECTORS SPECIFICATIONS
USER MANUAL
27
Command Box (laser control)
Control rack back panel connector
Panel socket Sub-D, 25 pins, female.
Figure 12: Command Box connector, female panel socket (front view)
PIN SIGNAL TYPE*** DESCRIPTION
1 12V_ENABLE_B
Output Power
Supply
12V DC power supply available for EXT_EN-
ABLE_B (max 250mA)
2 EXT_ENABLE_B Digital Input
Secondary external ENABLE signal:
- HIGH level: contact closed
- LOW level or disconnected: contact opened
3 RESERVED Digital Output DO NOT CONNECT
4 EXT_12V
Output Power
Supply
Auxiliary 12V DC power supply available for
drive input logical HIGH (max 250mA)
5 EXT_12V
Output Power
Supply
Auxiliary 12V DC power supply available for
drive input logical HIGH (max 250mA)
6 EXT_12V
Output Power
Supply
Auxiliary 12V DC power supply available for
drive input logical HIGH (max 250mA)
7 12V_ENABLE_A
Output Power
Supply
12V DC power supply available for EXT_EN-
ABLE_A (max 250mA)
8 EXT_ENABLE_A Digital Input
Primary external ENABLE signal:
- HIGH level: contact closed;
- LOW level or disconnected: contact opened
9 BUSY* Digital Output
This signal is used to know if the current
spooler is executing (marking in progress):
- ON during marking process
10
CONNECTOR
PRESENCE
Digital Input
This signal is used to check the presence of
the Command Box connector:
- HIGH level: normal operation;
- LOW level or disconnected
11 START_MARKING* Digital Input
This signal is used to start to the marking
process when a document or a sequence is
running in AUTO MODE** or WORK MODE**:
- HIGH level pulsed signal start the marking
process
12 EXT_KEY Digital Input
External KEY signal:
- HIGH level: contact closed;
- LOW level or disconnected: contact opened
13 STOP_MARKING* Digital Input
This signal is used to stop the marking pro-
cess:
- HIGH level pulsed signal stop the marking
process