Datalogic UniQ 1150-1X41, Product Reference Manual

Page: 77 / 128

TROUBLESHOOTING
PRODUCT REFERENCE GUIDE
69
TROUBLESHOOTING
If a problem occurs during operation, first check the following troubleshooting. If you
cannot fix the problem, contact Datalogic customer service (see “Technical Support” on
page vi).
List of warning and error states
POSSIBLE
CAUSE
ACTION
X1 - COMMAND
BOX CONNECTOR
OUTPUT STATE
Warning invalid start
sequence Incorrect turning-on
sequence Repeat the “Turning On
sequence” on page 44
SYSTEM_ALARM
POWER_ON
ENABLE_OUT
OFF
OFF
OFF
Warning laser warm
up
Laser marker leaves
the interlock error
state No action. The duration of the
laser warm up state is approxi-
mately 15 seconds
SYSTEM_ALARM
POWER_ON
ENABLE_OUT
OFF
OFF
OFF
System Error
Interlock error
- Check Interlock connector sig-
nals (see “Interlock” on page 21)
- Check Interlock connector
presence
SYSTEM_ALARM
POWER_ON
ENABLE_OUT
ON
OFF
OFF
Connector Presence
error
- Check X1.10 - CONNEC-
TOR_PRESENCE input signal of
the
X1 - Command Box connec-
tor (see “X1 - Command Box
(Laser Control)” on page 25):
HIGH level: normal operation;
LOW level or disconnected: sys-
tem error
- Check if X1 - Command Box
connector is present
System Error
Laser Source Error:
- Temperature error
- Master Oscillator
Error
- Back reflection error
Use Profilab application to con-
nect to the laser source and
report the error status code to
Datalogic Technical Support
SYSTEM_ALARM
POWER_ON
ENABLE_OUT
ON
OFF
OFF
STATUS LED DESCRIPTION
Blinking ORANGE
(1 Hz)
Blinking ORANGE
(0.5 Hz)
Blinking RED at
Power ON
Blinking RED after
KEY activation