Instruction
Manual
SE4-Plus
Series
18
3. MECHANICAL
MOUNTING
The emitting (
TX
) and receiving (
RX
) units must be installed with
the relevant sensitive surfaces facing each other. The connectors
must be positioned on the same side and the distance must be
included within the operating range of the model used (
see section
9 “Technical data”
).
Once positioned the two units, the two bars
should be aligned and parallel as much as
possible.
The next step, if necessary, is the fine
alignment, as shown in section 5 “
Alignment
procedures
”.
To mount the device, use the threaded pins
supplied, inserting them into the slots on the
two bars (Fig. 11)
The operator can use the pins and/or the rigid
mounting brackets – supplied with the device
– depending on the particular application
and/or the type of support on which the two bars must be mounted
(see Fig.12).
Fig. 12
Fig. 11
