Datalogic Rhino II A6, User Manual

Page: 16 / 78

Getting Started
10 Rhino™ II
Fasten the Cables
There are three different types of gaskets. Choose the right one
according to the size of the cable.
Type 1 and Type 2: cut the cable at its thinnest point (see the left
picture below). After the rubber gasket is cut off, nothing must
protrude from it (see the middle picture below). Slide the sealing
rubber over the cable (see the right picture below).
Place the sealing rubber into the appropriate cut-out (wide side up).
The upper edge must be flush with the housing. Fix the cable to the
corresponding tab with the cable tie, and then cut off the protruding
cable tie. Seal unused cable glands with rubber seal type 3.
Type 1: e.g. USB cable Type 2: e.g. power cable Type 3: no cable