Datalogic Rhino II A6, User Manual

Page: 26 / 78

Rhino II Configuration
20 Rhino™ II
button. To shut down the VMC, disconnect IGN or press the PWR
button. In Mode 0 you must use either IGN or PWR to control the
VMC. You cannot use both of them.
Mode 3
This mode is seldom used. The VMC powers up as soon as it is
connected to a power source. Both IGN and PWR are ignored.
Power off countdown
When powered down via IGN, the VMC will displays a countdown
screen advising the user the remaining time before the device shuts
down. The shutdown time is controlled by the configuration file.
Configuration
NOTE
If the VMC is powered up via IGN, but powered down via
PWR, it will immediately begin to power up again.
Key - Section name Parameter – Info
[Hardware]
PowerOnMode
Sets the Startup/Shutdown mode.
0 = IGN or PWR.
1 = IGN and PWR (default).
3 = AutoOn.
IgnStartTimeSec
Seconds after IGN goes high before theVMC begins
booting.
3 = default.