RAPID CONFIGURATION
1
1
1 RAPID CONFIGURATION
STEP 1
– CONNECT THE SYSTEM
The paragraphs in this step show a typical hardware setup depending on the Matrix 120
model and interface selection. Several other layouts are described in chapter 5.
Ethernet Connections
To connect the system in a Ethernet point-to-point configuration, you need the hardware
indicated in Figure 3. In this layout the data is transmitted to the Host from the Matrix 120 on-
board Ethernet interface by using a
CAB-ETH-M0x
cable. There is no need to use a
crossover adapter since Matrix 120 incorporates an autocross function.
Matrix 120 power and I/O device connections take place through the CBX connection box
using the
CAB-1011
accessory cable.
When One Shot or Phase Mode Operating mode is used, the reader is activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
Figure 1 - Ethernet Point-to-Point Layout
CBX
Host
Matrix 120
CAB-1011
CAB-ETH-M0x
1
2
Ethernet Interface
Main Serial Interface (Data Monitor)
External Trigger (for One Shot or Phase Mode)
3
10-30 Vdc
External Power for Matrix 120
and I/O Accessories
