Datalogic Lynx D, Instruction Manual

Page: 26 / 128

LYNX™
10
1
1.9 INDICATORS
1.9.1 LED Indicators
The following LED indicators signal the reader functions.
LED Behavior
Reader Power On Normal Functioning
Red
(Figure A,1)
lights until a beep occurs.
Then, it turns off. lights when a wrong read
occurs.
Lights for the entire time the
aiming system is enabled. It
turns off only when the trigger
is released and the aiming
system is disabled.
Green
(Figure A,2)
lights when a symbol has
been read and decoded.
1.9.2 Beeper
The Lynx™ basic software provides beeper signals for good/wrong reading or
successful/unsuccessful software upgrade. Its tone, volume and duration can be
directly configured by using the codes given in par. 2.11.
The application program can also manage the beeper (User Defined Beeper) when
the reader is controlled by a Host PC. It is possible to activate the beeper by sending
a command from the Host to the reader via the current communication interface.
The codes given in par. 2.11.1 allow defining the beeper properties.
NOTE
The configuration of the User Defined Beeper does not influence or
change the functioning of the beeper managed by the Lynx™ basic
software (see par. 1.9.2)