Datalogic DS8110, Reference Manual

Page: 61 / 282

E-GENIUS
49
4
4.1.2 Starting e-Genius
To access e-Genius:
NOTE: Before starting up or testing the scanner, it must be connected to a
CBX510 Connection Box (see section 3.9.1) or an SC5000 Controller
(see section 3.14) depending on the system configuration.
1.
Connect your computer to the scanner’s ETH 2 (setup) port using either the CAB-ETH-
M0x M12-IP67 ETHERNET CABLE or CBL-1534-0.2 ADAPT.CABLE ETH M12-TO-
RJ45F. If the ETH 2 (setup) port is taken, ETH 1 (host) can be used.
2. Turn on your computer.
3. If you are connecting to a stand-alone unit (not connected to an in-house network), you
must configure your PC’s IP Address to be in the same network as the scanner’s (or if
used, controller’s) IP Address.
To change your PC’s IP Address:
a. From the desktop, click the Start button, and then select Control Panel .
b. Type adapter in the search box, and then from the results, under Network and
Sharing Center , click View network connections .
c. Right-click Local Area Connection , and then select Properties .
d. Select the Networking tab. Under This connection uses the following items ,
click Internet Protocol Version 4 (TCP/IPv4) , and then click Properties .
e. Select Use the following IP address .
f. In the IP address field, type the first 3 octets of the IP address of the reader/controller
unit.
g. For the last octet, type a number that differs from the last octet in the
reader/controller’s IP address. The actual number used is not important as long as it
does not match that of the reader/controller.
Example: If the barcode scanne
r’s IP Address is 192.168.3.100, set your PC’s IP
Address to 192.168.3.101.
h. In the Subnet mask field, type 255.255.255.0
i. Click Okay .
4. Open a web browser and enter the IP address for the DS8110/DX8210. If the correct IP
address is entered, the DS8110/DX8210
Log On
window will appear.
The default setup IP address for all
DS8110/DX8210 units is: 192.168.3.100
(setup/ETH2) and 172.27.101.220 (Host/ETH1).