Datalogic C-BOX 400, Installation Manual

Page: 34 / 39

C-BOX 400/410
2
The internal LEDs of the C-BOX 4X0 (see Figure 15) indicate the following:
POWER ON
(
PWR
) (red) indicates the C-BOX 4X0 is connected to the power
supply and the power switch is ON.
WARNING
(
WL
) (red) indicates a warning or error condition. It is ON when the
Auto-Connection procedure with a Datalogic reader is in
progress (the system is busy), during a GET/TEST/SEND
procedure or during the Configuration Mode. It blinks when an
error condition occurs. Normally this LED should be OFF.
TRANSMISSION
(
TX
) (green) indicates there is communication between the
Application and the DeviceNet module. Upon communication,
this LED will blink slightly.
MODULE STATUS
(
MS
) (green and red) indicates the status of the DeviceNet module.
A correct module initialization is signaled by the green LED (on).
Both OFF = no power supply or module initialization in progress;
Green ON = the module is operating in normal condition;
Green FLASHING = waiting for commissioning;
Red FLASHING = recoverable fault;
Red ON = unrecoverable fault.
NETWORK STATUS
(
NS
) (green and red) indicates the status of the DeviceNet network.
A correct connection between the device and the network is
signaled by the green LED (on).
Both OFF = no power supply or device not on line;
Green ON = link OK, on line, connected;
Green FLASHING = on line, not connected;
Red FLASHING = connection timeout;
Red ON = critical link failure;
Both FLASHING = the device has detected a network access
error and is in Communication Faulted State. The device has
subsequently received and accepted an identify Communication
Faulted Request – Long Protocol message.
NOTE
According to the DeviceNet specifications, during the device
startup a LED test procedure is executed to check the MS and NS
LEDs. They flashed according to the following sequence:
1. MS green LED
2. MS red LED
3. NS green LED
4. NS red LED
22