Datalogic C-BOX 400, Installation Manual

Page: 27 / 39

INSTALLATION
2
2.5.4 C-BOX 4X0 Configuration for DeviceNet Slave Node
In order to setup the C-BOX 4X0, you need to install the function blocks in your PLC
programming software and configure it.
The procedure below can be generally applied for this purpose:
1. Start the DeviceNet configurator on the Master.
2. Insert the CD-ROM with the Electronic Data Sheet (.EDS) file into the drive of
the programming device (usually a PC).
3. Load the .EDS file in the configurator.
4. Configure the C-BOX 4X0 (through WinHost) setting the parameters according
to the DeviceNet network application as described in the configurator's Help On-
Line or User's Manual.
NOTE
Further information on DeviceNet protocol and Flow control is
provided in the C-BOX 400/410 DeviceNet document and Help On-
Line installed from the configuration CD-ROM provided in the C-BOX
package.
15