Datalogic AI7000, Product Reference Manual

Page: 88 / 352

ELECTRICAL INSTALLATION
74
AV7000 LINEAR CAMERA
Photoelectric Sensor Connections to CBX100/800
Barcode scanning applications may use a Datalogic photoelectric sensor as a trigger
device. The photoelectric sensor is wired directly into the CBX510 terminal block.
If your application uses a trigger other than the one specified by Datalogic, follow the
appropriate wiring diagram to assure proper wiring.
The following diagrams illustrate standard recommended wiring of the Photoelectric
Sensor to the CBX510 terminal block.
Photoelectric Sensor to CBX100 and CBX800 (NPN)
You must use shielded interface cables with this product. To maintain FCC compliance,
the cable shield must make a 360-degree connection to the shielded mating connector.
To confirm the photoelectric sensor is functioning properly, watch the TRIGGER LED
first in the CBX and also on the camera while the photoelectric sensor’s beam is
blocked. The Datalogic photoelectric sensor also includes a status LED.