Datalogic AI7000, Product Reference Manual

Page: 122 / 352

E-GENIUS
108
AV7000 LINEAR CAMERA
Enter the height that the RangeFinder is mounted above the scanning surface (Z axis)
Left Ignore Limit (-)
Enter the usable area on left side of the RangeFinder. This is referenced from the center of the
RangeFinder. Any codewords that are beyond the dimension set in this field will be ignored.
Right Ignore Limit (+)
Enter the usable area on right side of the RangeFinder. This is referenced from the center of the
RangeFinder. Any codewords that are beyond the dimension set in this field will be ignored.
Offset to RangeFinder Gain Setting
This parameter adjusts the gain value used by the Rangefinder. This is an offset that is applied
to the “Factory Gain Setting”. This value can be positive or negative. This value allows you to
replace a RangeFinder without having to re-calibrate the gain option. This must match the
package edge that the application spec requirements. For leading edge the transmit distance
must be greater than the size of the scanning plus the longest box going through the system.
Delay Distance (for Object Filtering)
This specifies the “delay” in transmitting the Rangefinder focus data. The size of this delay
helps with the ‘bounding’ of boxes to smooth the data for the sides. Essentially the range used
in the ‘bounding’ is about 25 mm [1 in] less than twice this number (in other words, if left at 70
mm [3 in], bounding is performed over approximately 127 mm [5 in]).
This distance is the distance it takes for the Position Sensor to prepare the focusing data for the
AV7000 focus. The focus Delay value in the DM3610 must match.
This value cannot be smaller than the minimum box size (minimum box size will be used in that
case). It cannot be larger than 200 mm [8 in].
Package Detection Debounce
This specifies the “Distance without height data” that must be observed before the package
detection algorithm terminates a box.
Be careful making this value much larger, as that will increase the sensitivity of the
RangeFinder to “belt noise”.
Enable Rough Dimensioning
Select the check box to allow the RangeFinder to return rough package dimensions.
Yaw
Select 0 or 180 from the drop-down list. This identifies the RangeFinder mount as Standard or
Non-Standard. This option is to assure that the correct focusing data is received for the correct
side AV700. If the orientation is incorrect the AV7000 will receive the focusing data meant for
the opposing side of the conveyor. The Yaw should either be 0 or 180, 0 being the standard
mount where the two indicator laser dots are upstream from the RangeFinder scan line. When
set to 180-degrees, the two indicator laser dots are downstream from the RangeFinder scan
line
DL L
IGHT
C
URTAIN AS
P
OSITION
S
ENSOR
S
ETTINGS
Connected to
Select a camera in the system to which the light curtain is connected.
Multicast LC Focus Data
Select Disable or Enable from drop-down.
D
IMENSIONER
(L
EGACY
)
AS
P
OSITION
S
ENSOR
S
ETTINGS
Place Dimensioning Results Based on Tach
Click the checkbox to enable the DM3610 to send dimensioning results based on a defined tach
value.