Datalogic AI7000, Product Reference Manual

Page: 62 / 352

ELECTRICAL INSTALLATION
48
AV7000 LINEAR CAMERA
CONNECTING AN AV7000 CAMERA
To install an AV7000, follow this sequence:
1. Complete mechanical installation (See “Mechanical Installation” on page 20.)
2. Complete electrical installation (See wiring illustrations provided in this chapter.)
3. Observe all electrical safety requirements outlined in this chapter.
4. Ground the mounting structure to protective earth (PE) ground.
5. If used, wire the photoelectric sensor (or other trigger) and the focusing device
(Light Curtain, S80, DM3610 or RangeFinder) to the CBX connection box.
6. Wire the tachometer to the CBX connection box.
7. Wire serial ports to the CBX connection box if needed.
8. Connect the M12 end of the Ethernet cable to the barcode reader’s HOST NET
port and network switch as required by your application.
9. Wire the Remote Display to the CBX connection box (if used).
10. Connect the AV7000 to its power supply.
11. Connect the power supply to the power source.
12. Setup / check camera operations .
TYPICAL CONNECTION BLOCK DIAGRAMS
In each diagram below a Speed Detector may take the place of the encoder when a tilt-
tray or cross-belt conveyance is used.
A CBX510 Connection Box can be used in place of the CBX100 Connection Boxes shown
in the following block diagrams.