Datalogic AI7000, Product Reference Manual

Page: 70 / 352

ELECTRICAL INSTALLATION
56
AV7000 LINEAR CAMERA
ELECTRICAL INSTALLATION GUIDELINES
It is important that you follow these general precautions when installing, setting up,
operating, maintaining, troubleshooting or replacing any Datalogic products, parts or
related equipment.
As you plan and install your barcode reader(s), be sure to keep the following guidelines
in mind:
• Determine the camera is in the proper location as outlined in Chapter 2.
• Leave adequate clearances (approximately 300mm [12 in]) for wiring.
• Route wires carefully to reduce or minimize electrical noise.
• When extraneous power and communication wiring must cross, make their inter-
section perpendicular. Avoid running power and data wiring parallel to each other.
If possible, maintain one of the following separations between the power and
data wiring:
• 300 mm [12 in] gap
• use steel conduit and 25 mm [1 in] gap
• 6.5 mm [0.25 in] of aluminum.
When planning your installation wiring, remember all power connections must be
quick-disconnect. For PERMANENTLY CONNECTED EQUIPMENT a readily accessible dis-
connect device must be incorporated in the building installation wiring. For PLUGGABLE
EQUIPMENT the socket-outlet must be installed near the equipment and must be easily
accessible
To assure no ESD damage will occur, be sure to observe the precautions outlined in the
Introduction to this manual.
Ground the mounting structure to safety ground (protective earth ground (PE)).