Data Translation DT3153, User Manual

Page: 115 / 140

Modifying the Device Driver
99
C
C
C
C
C
C
C
C
C
Windows 2000 Procedures
This section describes the following procedures in Windows 2000:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on page 101 );
• Removing a board from the device driver configuration (on page
102 ); and
• Uninstalling the device driver, if necessary (on page 103 ).
Adding a Board to the Device Driver Configuration
To add a board to the DT3153 Device Driver configuration, perform
the following steps:
1. If you have not already done so, install the additional board in
your computer following the instructions in the
DT3153 Getting
Started Manual , then power up your computer and any attached
peripherals.
Note: On power-up, the PCI bus takes one available interrupt
from system resources for the DT3153 board. If any devices are
using this interrupt, problems may arise. Verify that no other
devices in your system are using the same interrupt that the
DT3153 board is using and ensure that PCI interrupts are enabled
in your system BIOS.
2. Start Windows 2000.
The Found New Hardware dialog box appears.
3. Click Next .
4. Click Search for a suitable driver for my device (recommended) ,
then click Next.