6
Hard Power ON/OFF Switch -
After supplying power to the unit,
if the DAP III does not come on when you
press the soft ON/OFF button on the cover of the DAP III it will be necessary for you to open the cover of the DAP III
The DAP III can be shipped in three different confi guration of circuit boards; the basic DAP III board; the DAP III with
the relay board; and DAP III with the relay and analog boards. Each of these confi gurations are shown below and on
the following page. The confi guration in your unit is dependent on the type of cooling and options that was selected.
One of these photos will match the circuit board that is in your unit. However the hard ON/OFF switch is in the same
position on all boards
DAP III Circuit Board
Control Module
The use of the additional switches on the circuit boards will be discussed on page 78
78
of this manual.
Hard power ON/OFF Switch
Shown in the ON position
on the upper panel and OFF
position in the lower panel.
DAP III Control Module
Control Expansion Module
Summary of Contents for DAP III
Page 2: ......
Page 92: ...92 gForce Terminal Strip ...
Page 93: ...93 Remote DAP III Display Mount connection to Control Module ...
