Data Aire DAP III, Operation Manual

Page: 14 / 94

14
SUB-MENUS- continued
Group 4 – Alarms
4-1 Audio alarm mode
4-2 Change high temperature alarm limit
4-3 Change low temperature alarm limit
4-4 Change hi humidity alarm limit
4-5 Change lo humidity alarm limit
4-6 Firestat temperature alarm limit
4-7 Low discharge temp alarm limit
4-8 Compressor short-cycle alarm
4-9 Water under fl oor alarm action
4-10 No water fl ow alarm action
4-11 Person to contact on alarm
4-12 Message for optional alarm input 1
4-13 Delay for opt. alarm input 1
4-14 Message for opt. alarm input 2
4-15 Delay for opt. alarm input 2
4-16 Message for opt. alarm input 3
4-17 Delay for opt. alarm input 3
4-18 Message for opt. alarm input 4
4-19 Delay for opt. alarm input 4
4-20 Remote alarm number 1 selection
4-21 Remote alarm number 2 selection
4-22 Remote alarm number 3 selection
4-23 Remote alarm number 4 selection
4-24 No airfl ow alarm time delay
4-25 No water fl ow alarm time delay (locked)
MENU GROUP 5 IS LOCKED – NO CHANGES CAN BE MADE UNTIL
MENU IS UNLOCKED
Group 5 – Confi guration
5-1
Sensor location
5-2 Defi ne password
5-3 Reduced Function Mode (RFM) active
5-4 Compressor(s)
5-5 Reheat stage
5-6 Humidifi er
5-7 Water valve mode
5-8 Water valve voltage control range
5-9 Reverse acting water valve
5-10 Humidifi er autofl ush timer
Only displays when infared humidifi er installed
Group 6 – Network
6-1 Unit and network ID
6-2 Network protocol
6-3 IP address
6-4 Netmask address
6-5 Router address
6-6 UDP port
6-7 Ethernet TCP port
6-8 Baudrate
(Only appear when ModBusRTU, Modbus ASCII, BACnet MS/TP and
Johnson Control N2 protocol is selected. Requires RS-485 communications card.)
6-9 Network ID
6-10 Device ID
(this menu only shows when BACnet MS/TP or BACnet Master is selected)
6-11 Max Master
(This menu only shows when BACnet MS/TP is selected.)
Menus 6-12 through 6-15 only appear when SNMPv1/v2 is selected.
Shaded menus only displayed when
Ethernet card is installed and confi gured
for Bacnet IP, MODBUS TCP or SNMP