Dascom T2150, User Manual

Page: 149 / 166

User guide Emulations
141
LC printing
Certain professional applications may require unusually large char-
acter sizes. Therefore your printer has the possibility of scaling stan-
dard size characters up to factor 99 by means of control sequences
(LCP*).
The Header sequence defines the parameters (e.g. height) once.
This definition remains until the printer is switched off.
The printable LCP* information is transmitted in an LCP “bracket”
(SI).
The following character sets (with national characters) are available:
The character sets are selected via the following LCP sequence
ESC ”P“ ”L“ ”S“ n ESC ”\“. The value of n may range between 01 and
02 (as ASCII characters) – see ID column in the above table.
To select e.g. the german character set, you must use the following
data set:
The printout of LCP characters can be selected in all of the
emulations. Prerequisite: Printer must be in Barcode mode.
Note that this printer supports some scalable fonts in the
LQ-2170 emulation if a compatible driver is used.
* Large Character Printing
ID 23 24 40 5B 5C 5D 5E 60 7B 7C 7D 7E
US ASCII 01
# $ @ [ \ ] ? ` { | } ¯
GERMAN 02
# $ § Ä Ö Ü ? ` ä ö ü ß
ASCII ESC P L S 0 1 ESC \
hex. 1B 50 4C 53 30 31 1B 5C
dec. 27 80 76 83 48 49 27 92