DARKROOM AUTOMATION F-STOP, Instruction Manual

Page: 9 / 26

3. Insert the burning card.
4. Press the expose key.
5. If more than one burn is to be made then return to step 2 and enter the next burn
exposure.
6. To burn within the just burned area go to the next section on progressive burning,
below.
7. If all burning has been completed then press the mode key twice. You will go
back to the base exposure display, passing the progressive burn display
p0.5
on the way.
Progressive Burning
Progressive burning is used to make a burn inside of a previously burned in section.
1. Press the menu key after the base burn (above) has been completed and
advance to the progressive burning display
p0.5
.
2. Set the progressive burn exposure with the arrow keys
p0.6
,
p0.7
...
3. Insert the burning card.
4. Press the expose key
5. To burn inside the just burned progressive burn return to step 2 and enter the next
progressive burn exposure.
6. If all progressive burning has been completed and you want:
To make another sequence of progressive burns inside this base burn, press
the menu key to go to the reset display
r
Î
.n
and press the up arrow so the
display shows
r
Î
.y
. This resets the progressive sequence. Then press the
menu key again to return to progressive exposures
p0.5
at step 2.
To make another base burn, press the menu key several times until the burn
b0.5
display appears.
To make another print, press the menu key several times until the base
exposure
2.0
display appears.
7