Basic Memory Operations
Entry and Exit
Make sure the memory feature is enabled. If the memory prompt does not show up
then enter setup mode and turn on the memory feature.
Enter memory mode from basic mode by pressing the menu button until the display
shows
m 1
. Select the number of the memory bank with the arrow keys and hold
down the menu key. The display will show the current memory step -
1E2.
in the
selected bank.
To exit memory mode hold down the menu key at a memory step display -
1E2.
,
3b.5
etc.. The timer will go back to the basic mode menu loop and the display will
show
m 1
.
Memory Display and Data Entry
Memory steps are displayed as
1E2.
:
Step #
Step type
Exposure
1
E
2.
The step number goes from
1
to
K
. Step numbers greater than 9 are represented
alphabetically:
A
for 10,
b
for 11,
C
for 12 ... to
K
for 20.
The step type is an alpha prompt -
E
for base exposure,
H
for high contrast,
L
for
low contrast - as shown in the table below.
The step exposure is shown as the most significant digit of the exposure. Exposures
less than one stop are shown as
.0
to
.9
and exposures greater or equal to one
stop are shown as
1.
to
9.
. The full exposure value can be viewed and altered by
pressing the menu key.
Empty, unprogrammed steps are displayed as
2--
.
12
Summary of Contents for F-STOP
Page 1: ...DARKROOM AUTOMATION MEMORY f STOP TIMER INSTRUCTION MANUAL...
Page 26: ......