Dantherm AC-24, Service Manual

Page: 24 / 52

Quick guide
This section gives a quick introdution on the use of the room thermostat. :
Function button on the unit
Operates only in ventilation mode
0 - Unit Standby
Operates with room thermostat
Turn on thermostat controller if off
SET:
Enter the temperature setpoint mode.
UP/DOWN: Adjust the setpoint temperature
( In temperature setpoint mode the digits flash)
SET: Save the new temperature setpoint.
• Disconnect the power from the unit.
• Press and hold the two buttons shown below.
• Power up the unit - with the buttons pressed.
Press and hold both buttons when powering up the unit.
FACTORY RESET (
FAC
is displayed)
Note:
Above mentioned factory reset does only apply on units with serial numbers after
1810000000000.
Contact Dantherm for thermostat controller factory settings for units with serial numbers
below 1810000000000.
Room thermostat:
Adjusting the setpoint
temperature.
Reset to factory settings
Operating the room thermostat
24