Dantherm AC-24, Service Manual

Page: 46 / 52

Introduction
Technical data for the AC 24 units.
*Note: All data regarding heating is only relevant for models with heating coil installed.
Performance
characteristics
The air conditioner has a maximum cooling capacity of 6.0 kW.
When the relative humidity of the air inlet is high, the air can be cooled below its dew point and
thus condense some of the water vapour to free water. This requires a certain amount of latent
cooling but provides a dehumidification process, which is an important factor in comfortable air
supply conditions.
The operating range is between 20 and 55 °C approximately and is controlled by the HP/
LP-pressure switch. In relatively dry locations the air temperature drop will depend on inlet
conditions.
Data Data and dimensions on the cabinet are shown in the following table:
Specification Designation Value 6,0 kW
Dimensions Height × width × depth
- mm
1110 x 754 x 920 mm
Weight kg 162
Cabinet material 0.9 mm galvanized sheet
metal plates
Packaging - Wooden pallet and
cardboard
Voltage supply V/PH/Hz 230/1/50
Max current Amp 16A
Airflow, evaporator,
Standard setup
2
)
m3/h 2,800
Cooling capacity, max W 6.000
Refrigerant/Load Type/kg R134a/2,3
Max. refrigerant pressure Bar 25
Operation temp. range C° 20-55
Minimum room
temperature setting C° 20
GWP
(Global Warming potential) 1430
IP 55
Locked rotor amperange
(LRA) A 46
Technical data
46