46512-0999 <90-00083>
P
AGE
43
Here is the second 41 Edit screen:
7.
To edit the MAP Dsp or MAP Alarm Levels fields, press F3 (Data)
if you are in the second editing screen. The first editing screen ap-
pears.
8.
To change the MAP Dsp field only, go to step 11.
9.
To change to MAP Alarm Levels field, press F4.
Position the cursor under the alarm level that you want to change
by using the left and right arrow keys.
Type the letter (A through D) of the new alarm level. Continue this
procedure until all changes have been made to alarm levels for the
selected MAP display.
All 64 alarm points in the display can be set to the same level by
holding down the Ctrl key and pressing F1 (level A), F2 (level B),
F3 (level C), or F4 (level D).
10.
Press F4 to return the cursor to the MAP Dsp field.
11.
To change the MAP Dsp field, type the new memory location.
12.
Press Enter. The second editing screen appears.
13.
To configure or change the alarm points, go to the next step. To exit
the derived display screens, press F10. The Derived Display menu
appears.
14.
In the Point field, type the number of the alarm point that you
want to configure. The alarm point can be from 1-64. The alarm
point is one of the points shown in the previous screen in the MAP
Alarm Levels field.
TIP - S
TEP
9
Press F1 (Ruler) to display the Point
Ruler. The ruler precisely identifies
the 64 alarm points. Point numbers
are shown vertically. For example,
a 2 above a 6 represents point 26.
C
AUTION
:
You can substitute the Alt
key for the Ctrl key. If you do
this, you will change the lev-
els on all displays.
C
AUTION
:
Do not press F8 (Finish), even
if you do not want to go to the
second editing screen.
MAP SYSTEM DEFINITION
CONTINUED
. . .
