2.2 Installation Orientation and Clearances
2.2.1 Surface Mounting
The drive can be installed horizontally (see
)
or vertically (see
) on any plain surface with
the PCB pointing towards the surface. Typically, the 6
mounting holes in the side flaps of the chassis are used for
installation.
For vertical installation, the upper two mounting holes can
be used as suspension holes.
NOTE
If the drive is installed on a sheet metal surface, the
clearance between the drive PCB and the mounting
surface must be observed. As a minimum, sheet metal
gauge 22, 33/1000 inch or 1 mm should be used. If
electrical contact with the mounting surface can not be
avoided an additional isolation foil should be used.
NOTE
For outdoor units, do not install the drive horizontally with
the PCB in the top or bottom. Water condensing on the
PCB cannot be properly drained.
175ZB036.10
Illustration 2.3 Horizontal Orientation
175ZB037.10
Illustration 2.4 Vertical Orientation
Mechanical Installation
VLT
®
Inverter Scroll CDS 801 Operating Instructions
MG10V402 - VLT
®
is a registered Danfoss trademark
9
2
2