Procedure
1.
Strip the motor cable, the mains cable, and the brake resistor cable. See
.
2.
Cut the grommets open to move the cables through them. Use the grommets delivered in the accessories bag.
•
Do not cut the grommet openings wider than what is necessary for the used cables.
•
If the grommets fold in when putting the cable, pull the cable back to make the grommets straight.
•
Use a cable gland as an alternative to the grommet in types where this is necessary.
3.
Put the cables - the DC supply cable, the motor cable, and the optional brake cable - in the openings of the cable entry plate. Use
the cable entry plate delivered in the accessories bag.
A
B
C
e
3
0
b
g
0
8
5
.1
0
A
The DC supply cable
C
The motor cable
B
The brake cable
Illustration 20: Cables through the Cable Entry Plate
e
3
0
b
g
0
8
6
.1
0
4.
Put the cable entry plate with the cables into the groove on the frame of the drive. To attach the cable entry plate, use the M4x10
screws delivered in the accessories bag.
Electrical Installation
Operating Guide | VACON® NX Inverters FI4-FI8
AQ299433367205en-000101 / DPD00908| 53
Danfoss A/S © 2019.07
Summary of Contents for VACON NX FI4
Page 1: ...Operating Guide VACON NX Inverters FI4 FI8...
Page 2: ......
