Danfoss Heating
9
GB
Occasionally you may need to remove a thermostat or other Z-Wave
device from the RZ1 receiver. To do this, follow the procedure below:
1. Press
PROG
to set the RZ1 into
PROGRAMME
mode.
2. Press the button for the associated channel to be un-bound/
disconnected (
RED channel LED will flash
).
3. Press the ‘exclude initiator’ button on the device to be removed
(On some devices you may need to press and hold the include
initiator button for up to 10 seconds).
4. When the device has been removed, the
RED
LED
for that
channel will illuminate continuously.
5. Press
PROG
to return to normal operating mode.
4.1 Disconnecting devices from the RZ1
4.2 Include devices to the network,
not using the RZ1 relay output
If you wish to include a device to the network but not use the relay
function of the RZ1, follow this procedure:
1. Press the
PROG
button the
PROG LED
should turn
RED
.
2. Press the
PROG
button for at least 3 seconds or until the
PROG
LED
goes out.
3. Press and release within 3 seconds the
PROG
button, the
PROG
LED
should flash
RED
slowly indicating that an inclusion has
started.
4. Begin the inclusion process on your remote device.
5. If the process is successful the
PROG LED
will show solid
RED
.
Press
PROG
to return to normal operating mode.
6. If unsuccessful the
PROG LED
will flash
ORANGE
quickly. Press
the
PROG
button to return to step 1 and try again.
7. Once the inclusion is successfully completed, press the
PROG
button to return to normal operating mode.
