RZ1 AND RZ1-HP
8
GB
4.0 Connecting devices to the RZ1
To establish a connection with another Z-Wave enabled unit (i.e. RET
BZ), the RZ1 must be placed into its
PROGRAMME MODE
.
Once the RZ1 is in
PROGRAMME MODE
, each channel will present
whether it has an existing binding in the following way:
Channel LED RED
= unbound/no device present.
Channel LED OFF
= Channel successfully bound/ device located and
communication established.
To establish communication and bind a device to the RZ1:
1. Press and release
PROG
button. The
PROG LED
will light up
RED.
2. Channels with no devices bound will show
RED LED
as well.
3. Press the button for the channel you wish to bind, the
LED
will
flash RED slowly.
4. Press the ‘
include initiator
’ button on the wireless device to be
connected to the RZ1 (On some devices you may need to press
and hold the include initiator button for up to 10 seconds).
5. Once binding has finished the
LED
for the channel just bound
will go out indicating success. If there was an error in the binding
process the
PROG LED
will
flash ORANGE rapidly
. If this occurs
acknowledge the error by pressing the
PROG
button and return
to step 1 to begin the process again.
6. Press PROG to return to normal operating mode (
PROG LED
shows
GREEN
).
