RZ1 AND RZ1-HP
10
GB
If you wish to exclude a device from the network that does not use
the relay function of the RZ1, follow this procedure:
1. Press the
PROG
button, the
PROG LED
should turn
RED
.
2. Press the
PROG
button for at least 3 seconds or until the
PROG
LED
goes out.
3. Press the
PROG
button until the
PROG LED
flashes
RED
slowly
indication that exclusion has started.
4. Begin the exclusion process on your remote device.
5. If the process is successful the
PROG LED
will show solid
RED
.
Press
PROG
to return to normal operating mode.
6. If unsuccessful the
PROG LED
will flash
ORANGE
quickly. Press
the
PROG
button to return to step 1 and try again.
7. Once the exclusion is successfully completed, press the
PROG
button to return to normal operating mode (
PROG LED
GREEN
).
4.3 Exclude devices not using the RZ1 relay
output from the network
If you already have a primary controller in the network and wish to
add the RZ1 as a secondary controller, follow the steps below: -
1. Place the RZ1 into programme mode by pressing the
PROG
button (Programme
LED
will turn
RED
)
2. Activate the include/bind initiator on the primary controller in
the network.
3. Press and hold the programme and channel buttons until the
RED LED
flashes slowly indicating that inclusion as a secondary
controller has been started.
4. The RZ1 will attempt to connect to the network.
5. Once the RZ1 has successfully been incorporated into the
network, the programme
LED
will return to its continuously on
RED
state.
4.4 Including the RZ1 as a secondary controller
to a network
