Signal
Type
Direction
Range
Description
CurChgLim
U16
Output
22 – 333
CurChgLim defines the maximum rate of change of current for the group of
outputs. This parameter is only used when the output’s PinConfig is 4 or 5.
111 is 11.1 mA/ms.
DitherFreq
U16
Output
40 – 250
Sets dither frequency when output dither is enabled for the group.
40 is 40 Hz.
ReqFreq
U16
Output
30 – 4000
Sets the base PWM frequency for the group.
30 is 30 Hz.
Outputs – Digital Outputs
The output status of digital outputs on connectors and pins C1p06, C1p07, C1p08, C1p09, C1p10, and
C1p11 is described.
Signal
Type
Direction
Range
Description
Pin _MFOut
Bus
——
——
Config Bus
——
——
DefOutputValue BOOL
Output
——
Default Output value used when the IO module has not received an output
command within the previous TimeOut_Output.
DigOut BOOL
Output
——
Output command
Outputs – MultiFunction Outputs
The output status of multifunction outputs on connectors and pins C1p12, C2p01, C2p02, C2p03, C2p04,
C2p05, C2p06, C2p07, C2p08, and C2p09 is described.
Signal
Type
Direction
Range
Description
Pin _MFOut
Bus
——
——
Config Bus
——
——
PinConfig U16
Output
0 – 8
Output pin configuration
0: Digital Output, Push/Pull
1: Digital Output, Sourcing
2: Digital Output, Sinking
3: PWM Output, 0 – 10000 [0.01% positive duty]
4: PWM Output, 0 – 30000 [0.1 mA]
5: PWM Output, 0 – 30000 [0.1 mA] Dither Enabled
6: PVE Output, 0 – 10000 [0.01% of PVE Power]
7: HBridge Output, 0 – 10000 [0.01% positive duty]
8: PWM Output 0 – 30000 [0.1 mA] current control bidirectional
DefPinConfig U16
Output
0 – 8
Default Output pin configuration used at startup before the master/slave
communication initiates.
0: Digital Output, Push/Pull
1: Digital Output, Sourcing
2: Digital Output, Sinking
3: PWM Output, 0 – 10000 [0.01% positive duty]
4: PWM Output, 0 – 30000 [0.1 mA]
5: PWM Output, 0 – 30000 [0.1 mA] Dither Enabled
6: PVE Output, 0 – 10000 [0.01% of PVE Power]
7: HBridge Output, 0 – 10000 [0.01% positive duty]
8: PWM Output 0 – 30000 [0.1 mA] current control bidirectional
DefOutputValue U16
Output
0 – 10000 or
0 – 30000
Default Output value used when the I/O module has not received an output
command within the previous TimeOut_Output. The output range depends on
PinConfig.
1000 is 10.00%.
or
1000 is 100.0 mA.
User Manual
PLUS+1® Compliant OX024-x10 Function Block
OX024-x10 Function Block
©
Danfoss | July 2018
11063395 | AQ00000104en-US0101 | 7