User Guide
MES 1003 WMS
Doc no. 100837-MAN – Rev. E1 – Rev. date 2022-10
© Danfoss IXA A/S | Page 4
1.
Introduction
1.1.
Purpose of the Manual
This manual provides information on functionality and maintenance of the Washwater Monitoring System. Descriptions
of functional modes and display examples
will
enable the user to understand the different user interfaces.
All trademarks and registered trademarks are the property of their respective owners.
Other available resources:
MES 1003 - Data Sheet
(100602-DSH)
MES 1003 - Installation Guide
(100838-MAN)
MES 1003 - Spare Parts Catalogue (101155-CAT)
These documents are available for download at the Danfoss IXA website, or from the supplier of the marine emission
sensor.
1.2.
Abbreviations and Definitions
Abbreviation
Description
ADU
Application Data Unit
CSV
Comma-Separated Values
DHCP
Dynamic Host Configuration Protocol
EGCS
Exhaust Gas Cleaning System
EOCR
Electrical Over Current Relay
LAN
Local Area Network
LCP
Local Control Panel
MBAP
Modbus Application
PDU
Protocol Data Unit
SPE
Signal Processing Engine
SU
Sample Unit
TCP
Transmission Control Protocol
WAU
Washwater Analyzing Unit
WMS
Washwater Monitoring System
WSR
Washwater Sample Pressure Reduction Unit
WSU
Washwater Sample Unit
Table 1: Abbreviations
Term
Description
Alarm
An alarm covers conditions where the WMS either malfunctions or exceeds the operational
limits.
Modbus
Communication protocol.
Operational mode
The WMS has the following operational modes:
Standby Mode
The WMS remains idle and does not perform any measurements.
Starting
The WMS starts the pumps but is not yet measuring
Sensing Mode / Operation
The WMS is measuring.
Verifying
The WMS remains idle and all pumps etc. are shut off – but the WMS is measuring
Table 2: Definitions
